|
360 panoramic imaging system - common problems
|
| Problem phenomenon | Troubleshooting methods |
| 1 | After installation, there is no response to operation 360. | Check if the wiring is correct |
| 2 | The 360 panoramic system does not display trajectory guidance lines. | Check if the trajectory guide line in the car owner settings is in the open state. |
| 3 | Start the vehicle, 360 does not have automatic 3D surround view. | Check the car owner's settings: power on surround view, whether it is in the open state. |
| 4 | Turn on the turn signal, but the 360 degree panoramic system display has not been triggered. | Check if the steering start is in the open state in the car owner's settings. |
| 5 | The original vehicle's radar triggered an alarm, but the 360 degree panoramic system display was not triggered. | Check the car owner's settings: whether the radar is activated and in the on state (premise: the product supports radar triggering) |
| 6 | How to cancel a custom license plate after setting it up? | Restore factory settings to cancel: custom license plate |
| 7 | Unable to operate settings 360 | When the vehicle is in R gear and in reverse mode, the 360 degree panoramic camera cannot be operated. |
| 8 | After purchasing a new car model, 360 does not display the purchased model | In the car model settings menu interface, swipe the car model left or right to see the new car model |
| 9 | Why does the 360 degree panoramic automatically turn off when the speed increases? | When the vehicle speed exceeds the limit set by the owner, the 360 degree panoramic view will automatically close. |
| 10 | The power on panoramic view has been turned on. When starting the vehicle, why hasn't 360 panoramic view automatically 3D surround view? | When the vehicle ACC is not turned off, restarting the vehicle (i.e. activating the 360 system) will not automatically wrap around the 360 panoramic view. |
